Switching Between Abutment Height Calculation Methods in Dental System 2025

Dental System 2025 introduces a new setting that allows switching between two methods of calculating the Top Cap Height during abutment validation.

According to the FDA, there is no standardized definition for calculating the top cap height of an abutment. As a result, some manufacturers calculate it from the top of the margin line, while others use the traditional calculation method.

To support these different requirements, Dental System 2025 introduces an optional setting that allows either calculation method to be used.

How It Works

A new checkbox has been added to the "Limitations" tab of the Abutment Kit settings in "Dental System Control Panel":

"Measure top cap height from the top of margin line"

• By default, the checkbox is cleared and the previous calculation method is used.
• The selected setting is saved for each abutment kit and loaded automatically.
• This setting is configured by the Library Provider.

Dental Designer behavior

• If "Measure top cap height from the top of margin line" is cleared, the top cap height is calculated using the previous calculation method.
• If "Measure top cap height from the top of margin line" is selected, the top cap height is calculated using the new calculation method.

This update ensures that both calculation methods are available and used appropriately per manufacturer needs, improving system flexibility and regulatory alignment.

Contact 3Shape Support if you have any further questions.
 
For full information on correct usage consult the official Safety and Setup Guide and the most current Manual.